Car Window Tint In 15 Simple Steps

Car window tints offers privacy and UV protection, but assess your skills before taking on this project yourself: At the very least, you’d better be good at measuring and cutting. This is a precision job but can be done by almost everybody.


1: For car window tint in 15 steps you will need the following tools and materials:

tinting film, an X-Acto knife, razors, a blow dryer or heat gun, 4-inch squeegees, small sponges, a 4-inch hard card , a bone tool, and a spray bottle filled with a mixture of dishwashing soap and water.


Cut the film in the shape of the windows. Set cutouts aside on a glass board or an area devoted to cut film. This can be done easily by using the outside of the car window as a template.

3: Spray the side window with the soap and water mixture.

4: Use a razor to go over the side window to remove any residue.

5: Use a 4-inch squeegee to get rid of any residue from top to bottom. Paste the residue out of the film.

6: Apply the tint to the side window. Leave 1/4 inch to 1/16 inch from the top edge of the window without tint. This will be covered when the window and door are closed.This step is very important with car window tint in 15 steps

7: Push the tint below the inner rubber seals of the window.

8: Use the card to make sure that the tint goes into all the corners.

9: Take a blow dryer in one hand and a squeegee in the other, and heat from the top on one side, working the tint with the squeegee on the other side in a horizontal motion. This should get out any remaining moisture from between the film and glass.This ensures that the film is cleanly stuck.

10: Use the same system to apply the tint film to the front window.

11: Follow steps 3 and 5 in applying the film to the back window.

12: Count the number of defroster heater lines on the back window.

13: Cut the rear window film into the required number of panels.

14: Place the first panel on the bottom, the second panel on top of the first, the third panel on top of the second and so on. Identify the heater line where two panels overlap.

15: Trim the film from over the defroster lines.

And there you have it…You have successfully used CAR WINDOW TINT with 15 simple steps to add a whole new feel and look to your car.

It could not be any easier than this!

Source by Stuart Mcntosh